PRESTRESSING SYSTEM
PRESTRESSING SYSTEM
Prestressed concrete is a form of concrete used in construction which is “pre-stressed” by being placed under compression prior to supporting any loads beyond its own dead weight. This compression is produced by the tensioning of high-strength “tendons” located within or adjacent to the concrete volume, and is done to improve the performance of the concrete in service. Tendons may consist of single wires, multi-wire strands or threaded bars, and are most commonly made from high-tensile steels, carbon fiber or aramid fiber. The essence of prestressed concrete is that once the initial compression has been applied, the resulting material has the characteristics of high-strength concrete when subject to any subsequent compression forces, and of ductile high-strength steel when subject to tension forces. This can result in improved structural capacity and/or serviceability compared to conventionally reinforced concrete in many situations. Prestressed concrete is used in a wide range of building and civil structures where its improved performance can allow longer spans, reduced structural thicknesses, and material savings compared to simple reinforced concrete. Typical applications include high-rise buildings, residential slabs, foundation systems, bridge and dam structures, silos and tanks, industrial pavements and nuclear containment structures.
PRESTRESSING SYSTEM
Pre-tensioned concrete is a variant of prestressed concrete where the tendons are tensioned prior to the concrete being cast. The concrete bonds to the tendons as it cures, following which the end-anchoring of the tendons is released, and the tendon tension forces are transferred to the concrete as compression by static friction.Pre-tensioning is a common prefabrication technique, where the resulting concrete element is manufactured remotely from the final structure location and transported to site once cured. It requires strong, stable end-anchorage points between which the tendons are stretched. These anchorages form the ends of a “casting bed” which may be many times the length of the concrete element being fabricated. This allows multiple elements to be constructed end-on-end in the one pre-tensioning operation, allowing significant productivity benefits and economies of scale to be realised for this method of construction.The amount of bond (or adhesion) achievable between the freshly set concrete and the surface of the tendons is critical to the pre-tensioning process, as it determines when the tendon anchorages can be safely released. Higher bond strength in early-age concrete allows more economical fabrication as it speeds production. To promote this, pre-tensioned tendons are usually composed of isolated single wires or strands, as this provides a greater surface area for bond action than bundled strand tendons.
Unlike those of post-tensioned concrete, the tendons of pre-tensioned concrete elements generally form straight lines between end-anchorages. Where “profiled” or “harped” tendons are required, one or more intermediate deviators are located between the ends of the tendon to hold the tendon to the desired non-linear alignment during tensioning. Such deviators usually act against substantial forces, and hence require a robust casting bed foundation system. Straight tendons are typically used in “linear” precast elements such as shallow beams, hollow-core planks and slabs, whereas profiled tendons are more commonly found in deeper precast bridge beams and girders.
Pre-tensioned concrete is most commonly used for the fabrication of structural beams, floor slabs, hollow-core planks, balconies, lintels, driven piles, water tanks and concrete pipes.